
Heat setting
G-955Heat Setter
G-955 sets the shape of the lasted upper in three stages. The steam chamber softens the leather so that it takes the shape of the last without damaging its fibres. The hot chamber dries it with high-volume dry air, removing wrinkles and fixing the shape. The cooling chamber then brings the shoe down to a temperature at which it can go straight on to the next operation.
Request a quote or information

Highlights
- Three chambers in one machine (steam, hot and cool)
- Built-in pressurised steam generator, controlled by the PLC
- PLC with touch-screen HMI and stored programs for different leathers
- User levels, fault messages and remote access for service
Technical data
| Model | G-955 |
|---|---|
| Dimensions | 100 × 140 × 339 (386) cm |
| Weight | 700 kg |
| Power consumption | 12 kW |
| Voltage | 380 V |
| Capacity | 1,200 pairs / 10 hours |
Technical data may change with product development. Please contact us for a binding specification.
In detail
Steam chamber
The steam chamber is fed by a pressurised steam generator. Before the upper is tensioned, it softens the leather so that it can withstand the pressure, dry air and high temperature that follow without damage to its fibres and natural oils, and so that the upper takes the shape of the last.
Hot chamber
Softened by the steam tunnel, the shoe enters the hot chamber, where high-volume, dry and pressurised hot air removes the moisture the leather took on from the steam and ends the leather’s freedom to move. Because the upper is mounted on the last, the leather cannot react to shrinking by moving, so it is put under tension.
This tension removes wrinkles on the leather surface, the folds that form when a flat material takes a three-dimensional shape, and the gaps between last and upper at the toe and the opening. The leather leaves the chamber in its final form, so the shoe keeps the shape of the last even if it is heat-treated again after being taken off the last.
Cooling chamber
In the cooling chamber, air at ambient temperature brings the shoe coming out of the hot chamber down to a temperature at which it can be touched, so it can go straight on to the next operation without waiting.
Steam generator
The pressurised steam generator built into G-955 is controlled automatically by the PLC: the water level is monitored and the temperature is held at the set value. It is factory-set to 4 bar. The upper receives exactly the amount of dry steam it needs, so it does not get wet and no water stains are left on the leather, and uppers already mounted on the last can be softened as well.
PLC and touch screen (HMI)
Memory: programs for different leathers, changed with a single touch. Passwords: administrator and user passwords control who can run the machine, change settings and use service functions.
Fault notification: sensors connected to the PLC monitor the operating conditions continuously; if a fault occurs, the machine stops, a warning light comes on and the fault is shown on the screen.
Remote access: through the machine’s RJ45 network connection, the head office and authorised users can reach the machine; faults are reported to a chosen e-mail address and software problems can be diagnosed and solved remotely.
Efficiency
With the redesigned hot-air channels, the hot chamber needs 7 kW for heating instead of the 12 kW used in earlier models. The new channel design also increases the air flow and pressure on the shoe, so the drying coefficient of the shoe is 60% higher. The “owl wing” fan design developed by our R&D department keeps the machine quiet and saves energy.

